Description

Product introduction:

Piglets in the process of growth, there will be a similar against each other. To bite the tail of the natural phenomenon, caused serious bites, bacterial infection, the transmission.

And like the tail wagging the habit. So can affect the feed conversion rate, produce stress, caused increasing the cost of breeding process.

According to the above problem, we developed a new, applicable "hand electrothermal tail clamp"Hand electric tail clamp has the following features:

1.Hand electric tail clamp can be tail of piglets.

2.This product prices low, light weight, easy to carry, can be single hand operation, less consumption, low use cost.

3.This product after tail to stop bleeding, heal quickly.

4.Use the maintenance instructions:This product USES the 220 v, 50 hz single-phase power supply.

Power: 150 w5-10 minutes, turning on the power supply when the blade is heated to 300 Celsius or so before use; Please cut off power supply when temperature is too high, in order to avoid overheating accident, temperature when heated.Warning: the blade is in high temperature condition, do not contact with the human body, be careful burns!

5.Use after cut off the power and cooling after about 30 minutes, until completion of the blade heat loss, so as not to burn), with alcohol or water to clean the blade to dry.

Then packed into boxes, buy dry place preservation.

Use notice:

According to the experience of some domestic pig tail should be paid attention to:

Tail is generally not immune organ,

lest cause stress superposition.

Shall be carried out in the cool of the day time is advisable.

Tail long tail could keep a third, broken two-thirds is advisable.

Tail immediately after the increase in the volume of feed and water, and help to heal.

Conditional when can add vitamin K3.

Tail, piglet baoding first,

And then put piglet tails in blade card slot, strength minus the tail,

And at the same time the piglet tail incision to hot blade direction light pressure for 1 minute.